
How to Load and Feed Net Wrap in a Round Baler (Step-by-Step)
Loading net wrap looks simple until it isn't — roll orientation is the single most common mistake operators make. Here's the full process.
July 24, 2026
Loading net wrap is a five-minute job once you've done it a few times, but getting the roll orientation wrong is the single most common cause of feeding failures and torn wrap in the field.
Step 1 — Shut down and open the wrap chamber
Park on level ground, engage the PTO shutoff, and open the net wrap compartment access door per your operator's manual. Never work in the wrap chamber with the driveline engaged.
Step 2 — Remove the empty core
Pull the spent core (and any wrap remnants) fully out of the roll cradle and clear any loose netting from the feed rollers and brake assembly before loading the new roll.
Step 3 — Check roll orientation before you load it
This is the step operators skip and pay for later. Net wrap rolls are directional, and loading one backward is the single biggest cause of jams and torn wrap in the first few feet of a new roll. TD Strong and TD Edge+ rolls make this easier to get right: a color bar indicator runs down each side of the roll, with distinct left and right markings so you can confirm at a glance that the net will feed into the baler correctly before you close the chamber.
Step 4 — Thread through the feed rollers and brake
Feed the leading edge through the pinch/feed rollers and past the brake tensioner, following the threading path diagram on the inside of the access door. Make sure the wrap sits flat and centered — wrap feeding at an angle will tear at the rollers.
Step 5 — Close the chamber and run a test wrap
Close and latch the access door, then cycle a short test wrap (many balers have a manual "test wrap" function on the monitor) before putting a bale through. Confirm the wrap is feeding straight and the brake tension is holding without slipping.
Step 6 — Watch for the end-of-roll warning
On TD Strong and TD Edge+ rolls, the final 100 m carries a 3-inch (7.6 cm) red warning stripe. When it appears, it's your cue to have the next roll staged and ready rather than discovering an empty core mid-field. If wrap keeps tearing even after a correct load, the cause is rarely the loading step itself — see our troubleshooting guide for the most common culprits.
